Little-wonder 8160 User Manual download pdf (Page 12)

C. Directions for removing the Fan and

Talon ring, and reinstallation

1. Remove spark plug wires from spark plug.

2. Remove hose flange assembly.

3 Remove front plate assembly.

4. Remove bolt securing fan and talon ring to engine

crankshaft.

5. Remove talon ring

6. Align notch in the front plate of the housing, and fan

blades.

7. The fan a 3/4-16 nut welded on the fan hub.

Insert a 3/4-16 x 5” long grade 5 (or better)

bolt and jack or push the fan off the engine

(Little Wonder P/no 910505 pressure screw is

recommended.)

8. Replace damages or worn fan with a new

one. If during fan removal Key (64164-13) was

removed for the keyway, reinstall it by applying

a few drops of the Loc-tite 380 instant adhesive

(“Black Max” P/no 38050) on the key, and load

the key in the keyway of the shaft. (Cure time is

approx. 1 min.)

11.

Notches in the front

plate of the housing

9. Rotate the drive shaft with installed key by pulling

the starter rope until key is aligned with one of the

notches. Then align fan keyway with the drive shaft

hey and install fan (#720220).

10. Align talon ring hole with the fan holes, and install

talon ring (#720255).

11. Apply a few drops of the Loc-tite 380 instant adhesive

(Black Max P/N 38050) on a new bolt (#720502)

and complete fan and talon ring installation. Insure a

secure fit upon re-assembling.

Aligning holes

1 2 ... 7 8 9 10 11 12 13 14 15 16

No comments

Little-wonder 8160 User Manual Page 12