Little-wonder 8160 User Manual download pdf (Page 8)

2. The flange will activate the safety switch assy

(720232) that will allow you to operate the unit.

3. When hose is disconnected you can use the flapper

retainer to lock the flapper in the closed position

during the transportation.

E. Attach Boom to the Frame and

Connect it to the Hose

1. Insert shaft of the boom assembly (720331.7) into

the opening in the frame’s tube support assembly

(720306.7).

2. Connect link of the chain (720533) with the Hose

support band (72033317) using bolt (64123-61) and

nut (64229-02).

3. Repeat this step and connect second Hose band.

4. Be certain the intake hose boom is properly adjusted,

and hose can move freely.

5. Loosen knobs on inlet flange to rotate hose with

attached intake nossle (720113.17) to desired

position, then tighten knobs.

HOSE BAND

(720333.17)

BOOM ASSEMBL Y

(720331.7)

BOL T (64123-61)

LOCK NUT (64229-02)

1. Remove hose from the box and stretch it.

2. Hold the hose, and stretch each end as far as

possible to open internal diameter.

3. Insert intake nozzle assembly (720113.17) into one of

the open ends, by stretching ducting, and fitting the

edge of the sheet metal into the hose.

4. Install hose clamp and tighten.

5. Insert flange assembly into the remaining hose

opening using technique described above.

6. Install second hose clamp and tighten.

7. Put two hose bands (720333.17) over the hose.

8. Attach them to the chain of the boom assembly by

inserting bolt (64123-61) through the holes in the

hose band, and the last link of the chain. Tighten the

nut (64229-02).

WARNING DANGER

HOSE WEIGHT IS APPROX 26 LBS. OBTAIN

ADEQUATE HELP WHEN LIFTING.

F Hose Assembly

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Little-wonder 8160 User Manual Page 8

Comments to this Manuals